LOGICDATA SMARTneo Series - Duty cycle monitoring

USER MANUAL SMARTneo // PAGE 28
NOTICE
The function of automatic detection of drive types is available
only for LOGICDATA SLIMdrive drives.
NOTICE
This function is available only for motor group 1.
NOTICE
The automatic detection function of the SLIMdrive drive types
depends on the settings in the software parameters of the
SMARTneo. Please contact LOGICDATA for additional informa-
tion.
NOTICE
If the number or type of connected drives changes, the control
must be reset to the factory settings.
10.7 DUTY CYCLE MONITORING
The duty cycle monitoring causes the motor control to be disabled for a dened period of time when a de-
ned duty cycle is reached.
NOTICE
You can nd the precise specication of the duty cycle in the
data sheet.