USER MANUAL SMARTneo // PAGE 3
9.1 Adjusting the table height 20
9.2 Saving the memory position 20
9.3 Actuating the memory position 21
9.4 Manual reset 22
9.5 Correcting the height display 23
10 Software-dependent functions 24
10.1 Slow travel speed area 24
10.2 Safety area 24
10.3 Container stop and shelf stop positions 25
10.4 Plug Detection 26
10.5 Auto Detect Number of Drives 27
10.6 Detection of SLIMdrive drives 27
10.7 Duty cycle monitoring 28
10.8 Change of the display unit (cm or inches) 29
10.9 Changing the number of motors 30
10.10 Control system to factory settings reset
(SO Menu) 31
11 Collision protection 33
11.1 Intelligent System Protection (ISP) 33
11.2 Drive back 34
12 Maintenance 34
13 Fault Removal 34
13.1 Possible malfunctions and their remedy 35
13.2 Error messages on the display
of the hand control 36
13.3 Click-Codes 39
14 Additional information 40
14.1 Technical specication 40
14.2 Disposal 40
To Next Page
Loading...
Need help?
General
