7
Power On Self Test (POST)
The Broadband DSL/Cable Firewall Router automatically
performs a Power On Self Test (POST) when powered on.
Successful powering up of the Broadband DSL/Cable
Firewall Router is indicated by five flashes of the red LED
marked Status on the topside of the Broadband DSL/Cable
Firewall Router. If the Red LED does not flash five times,
please contact your dealer for repair or replacement.
Resetting the Firewall Router
The Broadband DSL/Cable Firewall Router has a reset
button in the rear panel of the device. In some
circumstances you may need to reset the Broadband
DSL/Cable Firewall Router. Please follow the instructions
below to reset the Broadband DSL/Cable Firewall Router.
1. With the Broadband DSL/Cable Firewall Router
powered on, press the reset button once. The red
LED light that is marked as Status will then flash
once.
2. Reset the DSL/Cable modem.
To Next Page
Loading...