Loading the Default Values
If you make any errors while configuring the Broadband
DSL/Cable Firewall Router, or if you wish to reset the
Broadband DSL/Cable Firewall Router to default settings,
please follow the steps below. This procedure will reset the
settings to factory defaults.
1. On the desktop, open your web browser.
2. Type the default IP address (192.168.1.1) in
the Location box and press Enter.
3. The authentication dialog for the Broadband
DSL/Cable Firewall Router will then appear.
Type the default administration user name,
admin, and the default configuration password
0000 and click OK as shown in following figure.
4. Click the Set Factory Defaults button in the
left-hand column.
29
To Next Page
Loading...
Need help?
General
