Lovol TE304 - Tractor gear shift

Operation Instruction
3.5 Tractor steering
3.5.1 In
case of turn during tractor traveling, firstly press the horn switch on the steering column to give the
signal, then turn the tractor. If the vehicle traveling at high speed, please decelerate. The tractor should be
turned slowly and early at the slow curve with the steering wheel less turned and then less returned. In the
case of a sharp turn, turn the steering wheel later and quickly and turn and return it largely.
3.5.2 In
the case of tractor small turning or turning on soft ground, there may be steering failure due to front
wheel sideslip. At the moment, turn the steering wheel and depress the brake pedal at the corresponding
side simultaneously to help steering.
Warning: 1. When tractor traveling at high speed, do not use the one-
sided brake sharp turn. If the
front wheel sharp turning, causing the relief valve sounding squeak, the steering wheel
should be returned back a little to avoid hydr
aulic steering system overload for a long
time. Otherwise doing so will lead to failure of steering and therefore accident.
2.
In the case of tractor turning in field operations or prior to tractor reversing, it is necessary
to lift operating components of the agricultural implement off the ground in order to avoid
agricultural implement damages or casualties.
3.6 Tractor gear shift
3.6.1 8+2 gear:
 Main/Auxiliary gear shifting is controlled by 1 gear lever to realize the 8 gears. The main gear lever A can be
shifted to 4 gears(1,2,3,4) and 1 reverse gear R; the auxiliary gear lever B can be shifted to 2 speed zone (L is
low speed zone, H is high speed zone).
 When depressing the clutch pedal, push the auxiliary gear B lever from the neutral position backwards to low
speed gear L or forwards to high speed gear H.

Depress the clutch pedal, push the shifting lever A forward from neutral position to shift to gear 3 or pull
lever A backward to shift to gear 4. Shift the lever A to the right side and then push it forward to shift to gear
1 or pull lever A backward to shift to reverse gear R. Shift the lever A to the left side from the neutral
position and push it forward to shift to gear 2.
 Proper traveling speed not only get optimal production and economy, but also prolong the tractor service life.
It is not allowed for the tractor to work at overload state frequently. There must be some margin of power. In
case of field work, it is best for engine to run at about 80％ of rated load. If tractor works with light-duty
load and at not high speed, engage high 1gear and use small throttle to save fuel consumption.
24