Appendixes
Used parts Oil, fuel and solution
Note:
1. The dual-purpose oil for drive and hydraulic systems, diesel, diesel oil should be deposited for at least 48h to
keep its cleanness and ultimate machine performance.
2.
During the engine running, do not fill fuel tank. If tractor working under hot or sunlight, do not fill up fuel
tank. Once the fuel is spilled, please wipe it at once.
3. Never blend the fuel of different grades and different manufactures to maintain the engine performance.
4. Choose the tractor with heater. Antifreeze must be used for winter to avoid freezing the heater.
Note:
1. During running of the engine, do not fill fuel tank, in order to avoid degerous accident;
2. If tractor is working under hot or sunlight, do not fill up fuel tank, or the fuel will be overflowed due to
expansion, once it is the case, please wipe it off at once.
Important:
the cooling water shall be clean softwater (such as rain, snow or river etc.). When using hardwater,
such as that from wells, springs etc.), fill water tank after it is boiling and precipitating, in order to avoid damage
to water tank.
11.2 Main bolt/ nut tightening torque table
Table 11- 2 Main bolt/ nut tightening torque table
Name and Assembly Parts Thread
specification
Grade Tightening torque N·m
Bolts, nuts for connecting engine and clutch
housing
M10 10.9
52~90
Bolts for coupling clutch housing and the
rear axle box
M12 10.9
105~156
Bolts for holding bearings of shaft I, shaft II
M10 8.8 37~75
Bolt for connecting drive shaft shell and rear
axle housing
M12×1.5 10.9
106~158
Bolts f
or jointing driven wheel hub and
spoke plate
M16×1.5 10.9
240~335
Locknut of front tie rod
M16X1.5 8.8
270
Bolt for coupling front outer shaft and inner
shaft fittings
M14 8.8
122~185
Bolts for coupling front drive wheel and
front wheel hub and spoke plate
M14×1.5 10.9
178~235
Bolts for connecting front axle and bracket
M16 8.8
182
245
Bolts for attaching bracket and engine
M12 8.8 73~110
Bolts for attaching bracket and engine
M14X1.5 8.8 146~205
Bolts for attaching lifter housing and rear
axle housing
M10 10.9
52~90
Coupling olt of limit rod bracket
M16 10.9 200~310
80
To Next Page
Loading...
