LS Industrial Systems GIPAM - Command for Controlling CB On;Off

46
;AD7!===IgYfAUbiU`
 Setting Data
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Fault #1
Ir>
(1)
Is>
(1)
It>
(1)
In>
(1)
Ir>>
(1)
Is>>
(1)
It>>
(1)
In>>
(1)
Fault #2
OVR
(1)
UVR
(1)
VG>
(1)
SGR
(1)
VG>>
(1)
(1) 0
Sys.
(1)
CB
Local
ON
(0)
Local
OFF
(0)
Remote
ON
(0)
Remote
OFF
(0)
0 0
ON
(1)
OFF
(0)
Setting /
Reset
Relay
Setting
(0)
Fault
Reset
(0)
V0 Max
(0)
CB ON
Time
(0)
CB ON
Counter
(0)
SOE
Buffer
(0)
Varh
(0)
Wh
(0)
* ‘1’; Enable, ‘0’; Disable.
* The value between the brackets is a default.
11.3 Command for controlling CB on/off
To control CB on/off on remote, it transmits the command for selecting control point and
for operating control point sequentially.
11.3.1 SBO (Select Before Operate)
 It applies to command for CB Open/Close.
 Transmitting the command for selecting control point to GIPAM.
 GIPAM replies with ACK Signal.
 Transmitting the command for operating the point selected before
time’s up.
 GIPAM replies with ACK Signal as well as outputs the control
signal.
11.3.2 Reacting to other command after receiving the command for
selecting control point.
 Disregarding a command to control other CB.
 Canceling the selected point to control CB in the event of receiving the
command to control other one.
 Canceling the selected point if there is something wrong with the
command.
 Responding to a command that requests Measurement data normally.