LS Industrial Systems GIPAM - Settings

9
;AD7!===IgYfAUbiU`
5.4 Displays and Settings
5.4.1 GMPC is able to display the items in the table as below.
Displayed Parameters Details
Status of the Device Normal or Error Code
The Present Time Year/Month/Day/Min./Sec.
Selecting a TIME MASTER Selecting / Remove
SYNC. BROADCAST Selecting / Remove
I-NET ADDRESS 0x00 ~ 0xFF
Choosing a PROTOCOL MODBUS / GMPC(I-NET)
RS232 / RS485 RS232 / RS485
Setting the PARITY BIT No / Odd / Even
Communication Speed 2400 – 57600 bps
Condition of the TIME MASTER T/M LED
Synchronizing between the GMPCs SYNC LED
Self-Diagnostic ERR LED
Communication Status TXD, RXD LED
Communication Status (I-Net) RUN, IDLE LED
5.4.1 It is capable to monitor the items in the following table on the Remote
Control Center via GMPC.
Displayed Parameters Details
Status of the Device Normal or Error Code
The Present Time Year/Month/Day/Min./Sec.
Selecting a TIME MASTER Selecting / Remove
SYNC BROADCAST Selecting / Remove
Synchronizing between the GMPCs Selecting / Remove
I-NET ADDRESS 0x00 – 0Xff
RS232 / RS485 RS232 / RS485
Communication Speed 2400 – 57600 bps