LS Industrial Systems GIPAM - Internal Setting Protocol; Read Status Command

24
;AD7!===IgYfAUbiU`
9.5 Internal Setting PROTOCOL
[P1] + [P2] + [DEST] + [E:10:LEN] + [DATA-0] + … + [DATA-n] + [ECC]
It is used for monitoring status of GMPC or changing the setting information. And FN in
the data frame for transmission is 10 at this point.
The data in [DEST] is disregarded.
The data frame that GMPC has received is discarded when there is ECC error on it .
The data frame that GMPC has received is recognized as abnormal response (E bit = 1)
when there is an error in value on it.
The internal setting PROTOCOL is as follow.
9.5.1 READ_STATUS
PC → GMPC-III 0xFF + 0x00 + 0x?? + 0X41 + 0x01 + ECC
[DATA-0] 0x01 READ_STATUS
PC
← GMPC-III
0xFF + 0x00 + 0x?? + 0X4E + 0x01 + year + mon + day + hour
+ min + sec + err + t/m + sync_en + is_sync + inet_addr +
rs232/485 + baud_num + ECC
Host S
y
stem
GMPC
-
III
READ
_
STATUS etc.
Normal Response
/ ERROR