LS Industrial Systems GIPAM - GMPC-III Initial Settings; Initial Settings Procedure

14
;AD7!===IgYfAUbiU`
8.2 The first settings
8.2.1 SELF TEST
When GMPC is supplied the power, it carries out a self test within 2 or 3 seconds and
changed into ERROR DISPLAY Mode.
If there is not any errors on the device, it turns over into TIME DISPLAY Mode.
8.2.2 ERROR DISPLAY
It can be only displayed one of the Error Codes on the front window when an error is
on the device.
Error Code
Error 1 : An error while transmitting I-Net Data
Error 2 : An error about time data
Error 4 : An error on Serial communication Line(RS-232/485)
To move to the next menu, press the
[MENU] key.
8.2.3 HOUR/ MINUTE / SECOND DISPLAY
The Front window displays the present hour/minute/second.
Pressing the
[SEL]key once, it is changed from Display Mode to Setting Mode
and the value on the display window goes on and off. To increase this value press
the
[SEL]key.
Reaching the value you wish to change, press
[ENT]key to move to the next
step.
To store all the values changed, press the
[ENT]key at the last menu and then
the display window is changed into Display Mode automatically.
If you press the
[MENU] key while changing the values on the setting menu, all
the values that has been changed are canceled and it is changed into Display Mode.
To move to the next menu on Display Mode, press the
[MENU]key.