39
GIPAM User Manual
9-2. Replacement
If it is necessary to replace a device for any reason after installation, please follow
the steps below.
1) Switch off the AC power supply.
2) Disconnect the lines.
3) Take off the screws on the front and draw out the device.
4) For installing the device after replacement, take the step three to one.
5) Set CT ratio, PT ratio and wirings with DIP Switches.
6) Supply the control power(DC 110V) and check out the below.
- An input value of the present current is displayed on LCD after all the indicators
are on for a little while(0.5~0.6sec)
- "RUN .. " is displayd on DOT-Matrix LED of the protection part.
10. Ordering Information
GIPAM - 115 N
N Standard
S SOE Function
To Next Page
Loading...