LS Industrial Systems GIPAM - Page 73

17
;AD7!===IgYfAUbiU`
Pressing the [SEL]key once, it is changed from Display Mode to Setting Mode
and the value on the display window goes on and off. And each time pressing the
[SEL] key, it displays RS-232 or RS-485 on the window one by one.
To store the one selected between RS-232 and RS-485, press the
[ENT]key.
If you press the
[MENU] key while changing the values on the setting menu, all
the values that has been changed are canceled and it is changed into Display Mode.
To move to the next menu on Display Mode, press the
[MENU]key.
8.2.10 Parity Bit Setting
Parity is set in this menu.
To move to the menu setting parity, press
[MENU]key. And each time pressing
the
[SEL] key, it displays no, odd or even on the window one by one.
To store the one selected among them, press the
[ENT]key.
If you press the
[MENU] key while changing the values on the setting menu, all
the values that has been changed are canceled and it is changed into Display Mode.
To move to the next menu on Display Mode, press the
[MENU]key.
8.2.11 BAUD RATE DISPLAY
The front window displays speed for serial communication.
Pressing the
[SEL]key once, it is changed from Display Mode to Setting Mode
and the value on the display window goes on and off. To increase this value press
the
[SEL]key.
Reaching the value you wish to change, press
[ENT]key to store it and then
the window is changed into Display Mode automatically.
If you press the
[MENU] key while changing the values on the setting menu, all
the values that has been changed are canceled and it is changed into Display Mode.
To move to the next menu on Display Mode, press the
[MENU]key.