LS Industrial Systems GIPAM - Page 88

32
;AD7!===IgYfAUbiU`
- 1 : off, 0 : on ⇒ All Status bit
- 1 : on, 0 : off ⇒ ON out, OFF out Status
- Ir> : Time Delay Characteristic of OCR (R Phase)
- Ir>> : Instantaneous Characteristic of OCR (R Phase)
- V
G> : Time Delay Characteristic of OVGR
- V
G>> : Instantaneous Characteristic of OVGR.
- Sys. : Internal Error of GIPAM
- SOE = 1(ON) : Data exists in SOE Buffer at present.
11.1.2 CURRENT
- Requesting Current Information
Command 11h
Sub Command -
- Current Data
Command 01h
MSB (Byte 3)
Byte 2
Byte 1
R Phase Current
LSB (Byte 0)
MSB (Byte 3)
Byte 2
Byte 1
S Phase Current
LSB (Byte 0)
MSB (Byte 3)
Byte 2
Byte 1
T Phase Current
LSB (Byte 0)
Data Check Sum Check Sum
- The representation follows IEEE Standards (4 Byte Floating Point Number)
- Checksum(1Byte) = (Command 1Byte + Data 12Byte) / 256 ⇒ The residual
※ Checksum is the sum of each bytes not to include OVERFLOW
11.1.3 Line Voltage
- Requesting Line Voltage Information
Command 12h
Sub Command -