LSIS H100 Troubleshooting Manual

1. Basic Checklist
16
Initializing All Parameters 1.3.2
You can initialize the parameter that has been changed by the user to the initial state at the time of
delivery. Not only the entire parameter but a group of the parameter mode can be selected and initialized.
Step
Instruction
Keypad Display
1
Monitor mode is displayed.
2
Press the [MODE] key to move to the Config (CNF) mode.
3
Press the [Down] key to go to CNF-40 (Parameter Init).
Press the [PROG/ENT] key to configure the parameter
initialization options.

LSIS H100 Specifications

General

Brand	LSIS
Model	H100
Category	Inverter
Language	English