5.28.1 Current Analog Output
5.29 Digital Output
5.29.1 Multi-Function Relay Settings
5.29.2 Trip Output to Multi-Function Relay
5.29.3 Multi-Function Relay Terminal Delay Time Settings
5.30 Base Block
6 Learning Protection Features
6.1 Motor Protection
6.1.1 Electronic Thermal Motor Overheating Prevention (ETH)
6.1.2 Overload Early Warning and Trip
6.1.3 Stall Prevention and Flux Braking
6.2 Inverter and Sequence Protection
6.2.1 Input/output Open-phase Protection
6.2.2 External Trip Signal
6.2.3 Inverter Overload Protection
6.2.4 Speed Command Loss
6.2.5 Dynamic Braking (DB) Resistor Configuration
6.3 Under load Fault Trip and Warning
6.3.1 Fan Fault Detection
6.3.2 Lifetime Diagnosis of Components
6.3.3 Low Voltage Fault Trip
6.3.4 Output Block by Multi-Function Terminal
6.3.5 Trip Status Reset
6.3.6 Inverter Diagnosis State
6.3.7 Operation Mode on Option Card Trip
6.3.8 No Motor Trip
6.3.9 Low Voltage Trip 2
6.3.10 Inverter Pre-overheat Warning
6.3.11 Torque Detection Protection Action
6.4 Fault/Warning List
7 RS-485 Communication Features
7.1 Communication Standards
7.2 Communication System Configuration
To Next Page
Loading...
Need help?
General
