LSIS LSLV-G100 - Page 11

7.2.1 Communication Line Connection
7.2.2 Setting Communication Parameters
7.2.3 Setting Operation Command and Frequency
7.2.4 Command Loss Protective Operation
7.2.5 Setting Virtual Multi-Function Input
7.2.6 Saving Parameters Defined by Communication
7.2.7 Total Memory Map for Communication
7.2.8 Parameter Group for Data Transmission
7.3 Communication Protocol
7.3.1 LS INV 485 Protocol
7.3.2 Modbus-RTU Protocol
7.4 DriveView9
7.5 Compatible Common Area Parameter
7.6 G100 Expansion Common Area Parameter
7.6.1 Monitoring Area Parameter (Read Only)
7.6.2 Control Area Parameter (Read/ Write)
7.6.3 Memory Control Area Parameter (Read and Write)
8 Table of Functions
8.1 Operation Group
8.2 Drive Group (PAR→dr)
8.3 Basic Function Group (PAR→bA)
8.4 Expanded Function Group (PAR→Ad)
8.5 Control Function Group (PAR→Cn)
8.6 Input Terminal Block Function Group (PAR→In)
8.7 Output Terminal Block Function Group (PAR→OU)
8.8 Communication Function Group (PAR→CM)
8.9 Application Function Group (PAR→AP)
8.10 Protection Function Group (PAR→Pr)
8.11 2nd Motor Function Group (PAR→M2)
9 Troubleshooting
9.1 Trip and Warning