LSIS Master-K K200S - RUN and STOP LED Are off

Chapter 12 Troubleshooting MASTER-K
12-4
12.2.3 RUN and STOP LED are off
RUN and STOP LED are off
Is the power module
of expansion base
on?
Disconnect an expansion base
and cycle the power of main
power module
Contact the nearest LGIS
representative
NO
Check the power module of
expansion base
YES
Done
Is an expansion
base connected?
YES
NO
Cycle the power of main and
expansion power module
Are RUN and STOP
LED off?
Check the power module of
main base
YES
NO