Chapter 14 RS-422/485C function of K200S MASTER-K
14-5
14.6.2 High speed link parameter setting
1) The high speed link 1 is used for RS-422/485 communication.
2) Max. 64 data access blocks can be established, and remain block number as blank.
3) Data size can be set within 0 ~ 60 words, and do not set the period.
4) All device can be set as Tx or Rx device, but F area can not be Rx device.
① Number of data access block : Max. 64 blocks can be established.
② Station number : It can be set as 0 ~ 31.
③ Unit(module) type : Set the communication direction. (send or receive)
④ Tx Device : Set the source device. If the unit type is remote in, the Tx device is the
device of master station. Otherwise, it is the device of slave station.
⑤ Rx Device : Set the destination device. If the unit type is remote in, the Rx device is
the device of slave station. Otherwise, it is the device of master station.
⑥ Size : Set how many words will be transmitted. (range : 0 ~ 60)
⑦ Link : Enable / disable the communication
To Next Page
Loading...
