Touchclave Ecotech
42
Load Probe Fail
Load temperature Probe is not reading correctly.
Heater Over Temp
An over-temp thermostat on the element has tripped.
Cycle Aborted
Cycle was aborted with a menu operation while in the middle of a cycle.
Steam Purge Over Pressure
Chamber pressure has become too high during Steam purge stage.
Pre Vac Timeout
Pre Vac stage has failed due to chamber pressure not reaching the value set in software in the time
period set in controller software.
Draining Timeout
Draining stage has failed to complete in the time period set in the controller software.
Drying Timeout
Drying stage has failed to complete in the time period set in the controller software.
Air Equalisation Timeout
Air equalisation stage has failed to complete in the time period set in the controller software.
Water Fill Timeout
Boiler level has not been achieved in the time period set in the controller software.
Archive Failure
Flash card cycle data Failed to Archive.
Engineering Override Used
Engineering override was used during a cycle (Engineering Override can only be used by
maintenance engineer or above).
Chamber Over pressure
The Chamber pressure has exceeded the maximum value for the given stage.
To Next Page
Loading...