Lucent Technologies MERLIN LEGEND Release 6.1 System Programming And Maintenance

MERLIN LEGEND Communications System Release 6.1
System Programming and Maintenance (SPM)
555-661-140
Issue 1
August 1998
Programming with SPM
Page 97
Surrogate Mode Programming
then taken to the new installation site and used with the Restore option
to provide complete system programming for a new communications
system.
You do not “select” surrogate mode programmingyou enter it
automatically under the following conditions:
■ The PC is connected to the lower RS-232 port on a control unit
(direct local connection).
■ Only the processor and power modules are connected.
Once you enter surrogate mode programming, you must follow the
sequence of procedures shown below.
■ At the service location, perform the following:
1. System Erase
2. Program the Boards
3. System Programming
4. Backup
■ At the installation site, perform a Restore.
While you are in surrogate mode, the Pass-Thru and Password options
are not available.
NOTE:
Surrogate mode is available only through the local programming
port. You cannot access surrogate features through the system
programming console.

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English