Lucent Technologies MERLIN LEGEND Release 6.1 System Programming And Maintenance

MERLIN LEGEND Communications System Release 6.1
System Programming and Maintenance (SPM)
555-661-140
Issue 1
August 1998
Programming with SPM
Page 55
Using SPM
!Type the IS II/III password and press
1
.
!Type
DPV for the terminal emulation type and press
1
.
■ If you are working with IS II, the IS II main menu appears.
■ If you are working with IS III, the system prompts you for your
login registration. After you enter your login and press
1
, the
IS III main menu appears.
!To exit from IS II/III programming, press

(
([LW ).
The system prompts you for confirmation that you want to exit. After
confirmation the following message appears.
Password
The Password option is used by qualified service personnel to change
the modem connection password. A password is always required to
establish a connection with the built-in modem. The password always
consists of seven characters. You can perform remote system
programming only if you enter the password correctly. A default
password is set at the factory. You must obtain this password from your
system consultant (SC).
Follow the steps below to change the modem connection password.
3DVVZRUG
8QL[GLVNXVDJH
LQIRUPDWLRQ
7HUP
5HWXUQLQJWR630

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English