LumaSense 320 Series - Table of Contents; Shipments to Lumasense for Repair; Transport, Packaging, Storage; Disposal; Decommissioning

IGA 320/23-LO Operating Manual Contents
•
iii
Contents
1 General ............................................................................................................................. 5
1.1 Information about the user manual ...................................................................... 5
1.1.1 Legend ...................................................................................................................... 5
1.1.2 Terminology ............................................................................................................. 5
1.2 Safety ....................................................................................................................... 5
1.3 Limit of liability and warranty .............................................................................. 5
1.4 Unpacking the Instrument ...................................................................................... 6
1.5 Service Request, Repair, or Support ...................................................................... 6
1.6 Shipments to LumaSense for Repair ..................................................................... 7
1.7 Transport, packaging, storage ............................................................................... 7
1.8 Disposal / decommissioning ................................................................................... 7
2 Introduction ..................................................................................................................... 9
2.1 Appropriate use ...................................................................................................... 9
2.2 Scope of delivery .................................................................................................... 9
2.3 Technical data .......................................................................................................... 9
2.4 Dimensions ............................................................................................................ 11
2.4.1 Instrument .............................................................................................................. 11
2.4.2 Optics ...................................................................................................................... 11
Optical Head Type I (Fixed Adjusted) ....................................................................................... 11
Optical Head Type II (Fixed Adjusted) ...................................................................................... 11
Optical Head Type II (Focusable) .............................................................................................. 11
2.5 Physical User Interface .......................................................................................... 12
2.6 Accessories (Optional) .......................................................................................... 12
2.6.1 Mounting................................................................................................................ 12
2.6.2 Air purge ................................................................................................................ 12
2.6.3 Displays ................................................................................................................... 12
3 Controls and Connections ............................................................................................ 13
3.1 Electrical Installation ............................................................................................ 13
3.1.1 Pin assignment of the male socket on the back of the pyrometer .................... 13
3.2 Connecting the pyrometer to a PC ...................................................................... 14
3.2.1 Connecting to RS485 interface / baudrate ........................................................... 14
3.2.2 Wait time t
w
........................................................................................................... 15
3.2.3 Connecting additional analyzing devices ............................................................ 15
3.3 Mechanical Installation ........................................................................................ 15
3.3.1 Fiber optic............................................................................................................... 15
3.3.2 Optical head ........................................................................................................... 16
3.4 LED targeting light ................................................................................................ 16
3.5 Optical head ........................................................................................................... 17
3.5.1 Spot size data (measuring distance from the front of the lens) ........................ 17
3.5.2 Adjusting the required measuring distance with optical head Ι or ΙΙ, fixed
adjusted ............................................................................................................................... 18
3.5.3 Adjusting the required measuring distance with optical head ΙΙ, focusable .... 18