Lumel N30U User Manual

36
Type of analog output
4030
tYPa
w/r 0...2
Value
0 voltage input 0...10 V
1 current input 0...20 mA
2 current input 4...20 mA
Description
Baud rate
4031
bAud
w/r 0...5
Value
0 4800 bit/s
1 9600 bit/s
2 19200 bit/s
Description
3 38400 bit/s
4 57600 bit/s
5 115200 bit/s
Meter address. The write of the value 0 causes the
interface switching off
4033
Addr
w/r 0...247
Transmission mode4032
prot
w/r 0...3
Update transmission parameters. Causes the
application of introduced RS-485 interface settings.
4034
sAvE
w/r 0...1
value
0 RTU 8N2
1 RTU 8E1
2 RTU 8O1
3 RTU 8N1
Description
Write of standard parameters4035
SEt
w/r 0...1
Value
0 without changes
1 set standard parameters
Description
Password for parameters4036
SEc
w/r 0...6000
Value
0 without password
... Entry in parameters preceded by a
request about the password
Description
Current time4037
hour
w/r 0...2359
This parameter occurs in the ggmm format, where:
gg - means hours,
mm – means minutes.
The introduction of a wrong hour will cause the
setting of 23, however the introduction of wrong
minutes will generate the setting of the value 59.

Lumel N30U Specifications

General

Brand	Lumel
Model	N30U
Category	Measuring Instruments
Language	English