Lumel N30U User Manual

37
Bit 15 Break of the supply
Bit 14 Re-set of the RTC clock
Switch on/off the unit highlight4038
unit
w/r 0, 1
Value
0 highlight swiched off
1 highlight swiched on
Description
Reserved...
...
... ...
Meter status. Describes the current state of the
meter. Successive bits represent the given event.
The bit set on 1 means, that the event took place.
Events can be only erased.
Bit 13 Not used
Bit 12 Lack of communication with data memory
Bit 11 Wrong settings
Bit 10 Manufacturer’ s setting restored
Bit 9 Lack of measured values in data memory
Bit 8 Not used
Bit 7 Output plate is detected
Bit 6 Output plate – error or lack of calibration
Bit 5 Not used
Bit 4 Not used
Bit 3 Wrong configuration of the individual
characteristic
Bit 2 Not used
Bit 1 Not used
Bit 0 Averaging period is not elapsed
Bit 15 Not used
Bit 14 Not used
Meter status. Describes the current state of the
meter. Successive bits represent the given event.
The bit set on 1 means, that the event took place.
Events can be only cancelled.
Bit 13 Not used
Bit 12 Not used
Bit 11 Not used
Bit 10 Not used
Bit 9 Not used
Bit 8 Not used
4049 Status2 w/r
4048 Status1 w/r 0...65535

Lumel N30U Specifications

General

Brand	Lumel
Model	N30U
Category	Measuring Instruments
Language	English