What to do if images from Lumens Document Camera CL510 are too bright?
If the images outputted from your Lumens Document Camera CL510 are too bright, dark, or vague, press the [AUTO TUNE] button to automatically adjust to the optimal brightness and focal length.
How to fix a Lumens Document Camera when it is unable to focus?
If you are unable to focus your Lumens Document Camera, it could be that the document is too close. Try pressing [ZOOM -] on the Remote Control, or increase the distance between the document and the lens, and then press [AUTO TUNE]. Also, check the lens for fingerprints or stains. Clean the lens and then use [AUTO TUNE] to focus.
What to do if Lumens CL510 is unable to record images?
If you are unable to record images with your CL510 Lumens Document Camera: 1. Check if the stored data has reached the maximum size of the USB disk or internal memory. 2. Confirm the rotation angle. Recording may not be possible when the image is rotated by 90°/270°.
What to do if CL510 Lumens Document Camera fails to store images?
If your CL510 Lumens Document Camera fails to store images or react, check the following: 1. See if the stored data has reached the maximum size of the USB device or internal memory. 2. Make sure if the Capture function is set to Continuous mode or the time for capture is set to be long.
How to fix the ActiveX controls installation issues in Lumens CL510?
To resolve a warning message (“Windows has blocked this software because it can't verify the publisher.”) that appears when installing the ActiveX controls for your Lumens Document Camera, follow these steps to modify security settings and re-install the ActiveX control components: 1. Open the web page, click [Tools] in the function bar, then [Internet Options], then [Security], then [Custom Level]. 2. Select [Download Unsigned ActiveX Controls] and set to [Prompt], then click [OK]. 3. Exit the “Internet Option” setup screen, restart your IE browser, and install the control components according to the instructions on the screen.
What to do if the live image does not display after login to Lumens CL510 Document Camera website?
If the live image does not display after you login to the website for your Lumens Document Camera: 1. Install the ActiveX control according to the instruction on the screen. 2. If the instruction for installing the ActiveX control does not appear, confirm and remove the old version of ActiveX control components, and then re-install the ActiveX control components.
How to fix Lumens CL510 Document Camera boot without power signal?
Ensure that the power cord is securely plugged in to address the issue of your Lumens Document Camera booting without a power signal.
General| Frame Rate | 30 fps |
|---|---|
| Microphone | Built-in |
| Focus | Auto/Manual |
| Resolution | 1920 x 1080 |
| Connectivity | HDMI, USB |
| Lighting | LED |
| Audio Input | 3.5mm audio jack |
| Audio Output | 3.5mm audio jack |
| Compatibility | Windows, macOS |
| Sensor Resolution | 2 megapixels |
To Next Page
