Lumens VC-A71P

31
Initial Position
Last operation/First
default position
Select the camera lens
to return to the last
operated position or the
first preset position after
POWER ON.
Control Device Encoder / Controller
Control Device setting,
Controller: for joystick
Encoder: for tracking
system
Motionless
Preset
On / Off
When the function is
enabled, the screen will
Freeze when Preset is
executed. Freeze will be
released after Preset is
completed.
Control Port RS-232/RS-422
Choose whether the
control interface used is
RS-232 or RS-422
Protocol VISCA / Pelco D
Baud Rate 9600/38400
Choose the transmission
speed of the control
signal
VISCA Address 0 ~ 7
The Protocol set to
VISCA allows the
camera ID address to be
assigned. Select 0 for
automation.
PELCO D
Address
1 ~ 255
The Protocol set to Pelco
D allows the camera ID
address to be assigned.