SETUP
SWITCH TYPE ACTION
Omnillume Works like a standard on/off toggle switch but has the ability to modify color and brightness for the
lights that are attached to it with a press and hold action of the button.
Latching On-Off Standard toggle switch, Press button to turn On, Press again to turn Off.
Momentary Standard Momentary switch, Press button to turn On, Release to turn Off. (Example: a Horn button).
Switch Folder Acts as a folder to store previously dened switches that may have similar functionality. Works like a
standard on/off toggle switch for the rst switch in the list but has the ability to turn on and off other
switches with a press and hold action of the button.
Scene Select Acts as a collection of Scenes that have been created. Allows for grouping of Scenes on one switch.
Works best when you only want one scene in the list ON at a time.
Switches
Switch Types
continued...
Tips & Tricks
Take note that it takes time to issue commands over the power lines so the more commands that are attached to a switch the
more lag there will be from the issuing of the rst command to the issuing of the last command.
If a switch is dened with Spectrum Lights and a 2-color White/Blue light the only options for color changing with a press
and hold of the Omni-Llume button will be white and blue because the switch picks the least common color that the lights are
capable of producing. In some instances, it may be desirable to dene a simple PWM single color light such as Lumitec’s accent
lights as an RGBW Spectrum light so that if it is attached to a switch that creates a lighting scene, the lighting scene color may
be adjusted via an Omnillume switch. The accent light will not change color but by identifying the light group as an RBGW Spec-
trum Light it will not prevent the full-color Spectrum Wheel from being displayed.
Switches continued...
21
To Next Page
Loading...
