Installation Procedures
11. Next, you’ll be asked to insert the manufacturer’s installation disk into the drive selected (the
default is A:\) – type “C:\Lynx” in the text box, and click “OK”.
12. You will be prompted to select the device driver you are installing. “Lynx AES16” will be your
only choice. Select it and click “Next>”. (NOTE: In Windows 2000, choose AES16 from the list,
then click “Next>”. Click “Next>” on the subsequent confirmation window as well).
13. You may receive a warning that the driver has not been digitally signed by Microsoft. It is
perfectly safe to disregard this warning and click “Continue Anyway” to proceed with the
installation. (NOTE: In Windows 2000 click “Yes” to continue installation.)
14. The driver installation will continue. After several moments, the Hardware Update Wizard will
indicate that it has completed the installation. Click “Finish”. (NOTE: In Windows 2000 you will
be prompted to restart the computer. There is one remaining step, so choose “No.”)
AES16 User Manual 15
To Next Page
Loading...