Installation Procedures
2.2.2 Installing the Windows Version 2 Driver Package
1. When you start Windows after installing the AES16 into your computer, the New Hardware
Wizard will appear. Select “Install from a list or specific location” and click “Next >” to proceed.
(NOTE: In Windows 2000, click “Next>” on the New Hardware Wizard welcome screen, on the
Install Hardware Device Driver dialog box, choose “Display a list of the known drivers for this
device” and click “Next>”)
2. From the next window, select "Search removable media”. Click "Next >" to proceed. (NOTE: In
Windows 2000 select “Sounds, video and game controllers” as a hardware type, and click
“Next>”. From the next screen click “Have Disk”, then type in the drive letter of your CD-ROM
drive, i.e. D:\, then click “OK”. Select the AES16 or AES16-SRC from the list of choices and
click “Next>”.)
3. Windows will begin to search for the appropriate driver files:
4. You may receive a warning that the driver has not been digitally signed by Microsoft. It is
perfectly safe to disregard this warning and select “Continue Anyway.” (NOTE: In Windows 2000
click “Yes” to continue installation.)
5. The driver installation will continue. After several moments, the new hardware wizard will
indicate that it has completed the installation. Click “Finish”:
6. Reboot the computer. The AES16 Card and Lynx Mixer application are now ready to use.
AES16 User Manual 9
To Next Page
Loading...
Need help?
General