Getting Started
7. In Peak, click “Audio Out” from the Audio menu. Verify that there is a check next to
“CoreAudio…”
8. Click “Hardware Settings…” from the Audio menu. Verify that the AES16 appears as the Output
device. Click “OK”.
9. Click “Play” from the Peak transport. You should see meter activity and the counter progressing.
10. Check the Lynx Output mixer and confirm meter activity for Digital Out 1L and Digital Out 1R. If
you have speakers or headphones connected to your destination device, you should also hear audio
and see meter activity.
If the test did not operate as described or you received any errors, please refer to Section 10
Troubleshooting.
AES16 User Manual 36
To Next Page
Loading...
Need help?
General