mabe Kraken - Consumer Error Mode Entry

Ingeniería de Servicio
- 53 -
Consumer Error Mode Entry
Entry into Consumer Error Mode
 From an idle state only (all LEDs off), press and hold Start button for 10 seconds.
 After holding Start for 10 seconds, all LEDs will turn on, signifying the user may
release the Start button.
Behaviors While In Consumer Error Mode
 The Pause and Lid Locked LEDs should be constantly blinking while in CEM.
 The first fault, if present, will show on the display.
 Pressing Start will display the next fault code.
o Models without 7-segment display: Fault code will blink in binary – the
consumer will report which LEDs are blinking and which are not. See Binary
Display Fault Chart.
o Models with 7-segment display: Fault code will blink on the 7-segment display.
 At the end of the fault list or if no faults present.
o Models without 7-segment display: All status LEDs will blink.
o Models with 7-segment display: 7-segment display will blink “-“.
Exiting Consumer Error Mode
 Pressing any button (other than Start) or turning any knob will exit Consumer Error
Mode.
 Consumer Error Mode will time out after 10 minutes.