SECTION 7 MAINTENANCE AND SERVICING
Form 169000 / 169040 111 Revision D
A40-D Headers
(Cont’d)
NOTE
To prevent binding and/or excessive wear
caused by sickle pressing on guards, do
not
over-grease. If more than 6 to 8
pumps of grease gun are required to fill
the cavity, replace the seal in the sickle
head.
SICKLE HEAD BEARING (1 PLC)
SICKLE DRIVE BEARING (1 PLC)
GAUGE ROLLER BEARINGS (2 PLCS)
BOTH SIDES - IF INSTALLED
High Temperature Extreme
Pressure (EP2) Performance With
1% Max Molybdenum Disulphide
(NLGI Grade 2) Lithium Base.
A40-D HEADER LH SIDE
TINE BAR BEARING
(4 PLCS EACH TINE BAR)
To Next Page
Loading...
