SECTION 7 MAINTENANCE AND SERVICING
Form 169000 / 169040 110 Revision D
III. A40-D HEADERS
REEL SHAFT BEARING (1 PLC)
SICKLE DRIVE BEARING (1 PLC)
AUGER SHAFT BEARING (1 PLC)
A40-D HEADER RH SIDE
NOTE
To prevent binding and/or
excessive wear caused by sickle
pressing on guards, do not
over-
grease. If more than 6 to 8 pumps
of grease gun are required to fill
the cavity, replace the seal in the
sickle head.
High Temperature Extreme
Pressure (EP2) Performance With
1% Max Molybdenum Disulphide
(NLGI Grade 2) Lithium Base.
SICKLE HEAD BEARING (1 PLC)
To Next Page
Loading...
