OPERATION
9. Slip the taper lock bushing (A) onto the s haft at the
same depth measurement recorded in Step 4., page
93. Pulley will be drawn into taper lock when tightening.
10. Repeat Step 9., page 94 for the second pulley.
11. Verify pulley face alignment by using a long straight
edge (verified straight), and bridge both faces to a
toleranceof3/16in. (5mm).
Figure 3.113: Drive Belt and Pulleys on Left
Side of Conditioner
12. Install drive belts (A).
13. Remove jam nut (B).
14. Turn adjuster nut (C) to remove all slack from tensioner.
Figure 3.114: Jam Nut and Adjuster Nut on Left
Side of Conditioner
147910 94 Revision A
To Next Page
Loading...
