OPERATION
1. Following the transport to field decal (A), move
transport switch to the upper position (C) and ensure
that light (B) is NOT illumin ated.
Figure 3.
88: Remote Control
2. While the light is NOT illuminated, operate the lift
control lever (as if raising the mower conditioner) to
fully extend the lift cylinders and raise the cutte rb ar
off the transport assembly support. The carrier frame
latch will automatica lly ope n.
Figur
e 3.89: Raising Mower Cond itioner
147910
7
7
Revision A
To Next Page
Loading...
