MacDon R80 - Maintenance Schedule

MAINTENANCE/SERVICE
Form # 169053 111 Model Year - 2010
7.13 MAINTENANCE SCHEDULE
The following maintenance schedule is a listing
of periodic maintenance procedures, organized
by service intervals. Regular maintenance is the
best insurance against early wear and untimely
breakdowns. Following this schedule will
increase machine life. For detailed instructions,
refer to the specific headings in Section 7,
Maintenance/Service. Use the fluids and
lubricants specified in Section 7.3.1
Recommended Fluids and Lubricants.
Service Intervals: The recommended service
intervals are in hours of operation. Where a
service interval is given in more than one time
frame, e.g. "100 HOURS OR ANNUALLY",
service the machine at whichever interval is
reached first.
IMPORTANT
Recommended intervals are for average
conditions. Service the machine more
often if operated under adverse conditions
(severe dust, extra heavy loads, etc.).
CAUTION
Carefully follow safety messages given
under Section 7.1 PREPARATION FOR
SERVICING, and Section 7.2
RECOMMENDED SAFETY PROCEDURES.
7.13.1 Break-In Inspection
BREAK-IN INSPECTIONS
HRS ITEM CHECK
1
Wheel Bolts
Torque 120 ft·lbf (160 N·m)
Drive Belts Tension
5
Hardware Torque. Refer to Section 7.3.2.
25
Drive Belts Tension
Drive Belts Tension
Cutterbar Lubricant
Change. Use only specified amount. Do not overfill.
50
Bevel Gearbox Lubricant
Pump Gearbox Lubricant
Change
100
Hydraulic Oil Filter Change
150
Bevel Gearbox Lubricant
Cutterbar Lubricant
Change
250
Cutterbar Lubricant Change