MAINTENANCE/SERVICE
Form # 169053 112 Model Year - 2010
7.13.2 Interval Maintenance
INTERVAL SERVICE
FIRST USE
Refer To
BREAK-IN INSPECTIONS (previous page).
100 HOURS OR
ANNUALLY *
1. Check Bevel Gearbox Lubricant Level.
2. Check Wheel Bolt Torques.
3. Check Conditioner Drive Belt Tension.
4. Check Hourglass Deflector Belt Tension –
16 Ft.
5. Grease Wheel Hub Bearings.
END OF
SEASON
Refer To Section 6.16 STORAGE.
10 HOURS OR
DAILY
1. Check Hydraulic Oil Level.
2. Check Hydraulic Hoses and Lines For
Leaks.
3. Check Hourglass Deflectors For Security
and Condition.
4. Check Tire Pressure.
25 HOURS
1. Grease Cutterbar Driveline Bearings.
2. Grease Roll Universal Shafts.
3. Grease PTO Shaft and Universals.
50 HOURS
1. Grease APT Pivot.
2. Grease Steering Cylinder Pivot
3. Grease Drive Belt Tensioner.
4. Grease APT Swivel.
5. Grease Roll Shaft Bearings.
6. Grease Lift Cylinder Pivot.
7. Grease Lower Link Pivots.
250 HOURS
1. Change Hydraulic Oil Filter.
2. Change Cutterbar Lubricant.
3. Change Bevel Gearbox Lubricant.
500 HOURS OR
3 YEARS
1. Change Hydraulic Oil.
1000 HOURS OR
3 YEARS
1. Change Pump Gearbox Oil.
* IT IS RECOMMENDED THAT ANNUAL MAINTENANCE BE DONE PRIOR TO START OF OPERATING
SEASON.
To Next Page
Loading...
