MacDon R80 - Recommended Lubricants

MAINTENANCE/SERVICE
Form # 169053 55 Model Year - 2010
7.3.2 Recommended Lubricants
Your machine can operate at top efficiency only
if clean lubricants are used.
• Use clean containers to handle all
lubricants.
• Store in an area protected from dust,
moisture, and other contaminants.
IMPORTANT
Do not overfill the cutterbar when
adding lubricant. Overheating and
failure of cutterbar components may occur
if overfilled.
CAPACITIES
LUBRICANT SPEC DESCRIPTION USE
13 Ft 16 Ft
High Temp. Extreme Pressure (EP2)
Performance With 1% Max Molybdenum
Disulphide (NLGI Grade 2).
Lithium Base
As Required
Unless
Otherwise
Specified.
--
SAE Multi-
Purpose
High Temp. Extreme Pressure (EP)
Performance With 10% Max Molybdenum
Disulphide (NLGI Grade 2).
Lithium Base
Driveline
Slip-Joints
--
Grease
NLGI 00 Synthetic EP
Conditioner
Drive
Gearbox
Lubricated For Life
16 oz. (454 grams)
Cutterbar
7 pints
(3.25 liters)
9 pints
(4.25 liters)
Traxon SAE
80W90
High Thermal & Oxidation Stability.
API Service Class GL-5
Pump Drive
Gearbox
2.1 qts (2.0 liters)
Gear
Lubricant
SAE 75W90
API Service
Class GL-5.
(SAE J2360
Preferred)
Fully Synthetic Gear Lubricant
Bevel
Gearbox
0.86 pints US (0.4 liters)
Hydraulic
Oil
Single Grade
Trans-
Hydraulic Oil *
** See Below For List of Recommended
Brand Names.
Hydraulic
Drive
Systems
39 gal. US
(147 liters)
48 gal. US
(180 liters)
* For Australian Units – Use SAE 15W40 complying with SAE specs for API Class SJ and CH-4 engine oil.
** The following oil company and equipment manufacturer brand names are recommended:
Petro Canada Duratran Case IH Hy-Tran Plus®
John Deere Quatrol® J20C Agco Power Fluid 821XL
** The following oil company and equipment manufacturer brand names are acceptable:
New Holland Hydraul Esso/Exxon Hydraul 56
Shell Donax TD