OPERATION
Form # 169053 20 Model Year - 2010
f. Secure pin with clevis pin (F), washers, and
cotter pin.
g. Assemble PTO driveline male half (G) onto PTO
shaft (H) on APT. Push male half so that PTO
shaft is at its fully compressed length.
h. Locate PTO shaft in hook (J).
6.3.4 3 Point Hitch (Cat. II, III, or IIIN) Set-
Up
a. Attach the 3 point hitch yoke (K) to the APT with
pin (L). The installation is similar to that
described in the previous section.
b. Secure pin (L) with clevis pin (M), washers, and
cotter pin.
c. The arms (N) on APT yoke can be set up to suit
the tractor hitch arms:
1. Remove pins (O) from arms.
2. Remove arms (N) from APT yoke.
3. Re-install arms on opposite ends of yoke as
shown.
4. Re-install pins (O) in arms.
(continued next page)
CATEGORY II or IIIN
N
CATEGORY III
O
L
M
K
F
H
G
J
To Next Page
Loading...
