MacDon R80 - Page 115

MAINTENANCE/SERVICE
Form # 169053 113 Model Year - 2010
ACTION: 9 - Check 6 - Lubricate S - Change
Hour Meter Reading
Date
Serviced By
MAINTENANCE
RECORD
FIRST USE
Refer To BREAK-IN INSPECTIONS (previous page).
100 HOURS OR ANNUALLY
S
Hydraulic Oil Filter - First 100 H Only
9
Conditioner Drive Belt Tension
9
Hourglass Drive Belt Tension – 16 Ft
9
Wheel Bolt Torque
6
Wheel Hub Bearings
9
Bevel Gearbox Lubricant Level
END OF SEASON
Refer To Section 6.16 STORAGE.
10 HOURS OR DAILY
9
Hydraulic Hoses & Lines
9
Tire Pressure
9
Hydraulic Oil Level
9
Cutter Blades, Deflectors & Discs
25 HOURS
6
Roll Universal Shafts
6
PTO Shaft and Universals
6
Cutterbar Driveline Bearings
NOTE: A RECORD OF DAILY MAINTENANCE IS NOT
NORMALLY REQUIRED BUT IS AT THE
OWNER/OPERATOR’S DISCRETION.
50 HOURS
S
Cutterbar Lube – First 50 & 150 H
S
Bevel Gearbox Oil - First 50 & 150 H
S
Pump Gearbox Oil - First 50H
6
Lower Link Pivots
6
Lift Cylinder Pivots
6
Drive Belt Tensioner
6
APT Swivel
6
Roll Shaft Bearings
6
Steering Cylinder Pivot
6
APT Pivot
250 HOURS
S
Cutterbar Lube
S
Bevel Gearbox Lube
S
Hydraulic Oil Filter
500 HOURS OR 3 YEARS
S
Hydraulic Oil
1000 HOURS OR 3 YEARS
S
Pump Gearbox Oil