Conditions: set valet mode
set 4, 8 or 12 hour cycle (Installation guide page 37)
switch on TIMER on remote Press buttons and shortly at the same
time.
Press buttons and shortly at the same time.
Remote will beep once and an icon TIMER will appear on display.
You will turn it off by pressing the buttons and shortly at the same time again.
4.18. Cold start
Alarm allows you to make the execution of a regular cold start. In the service menu is possible
to set start when cold or heat.
Conditions: set time of start – page. 60
set temperature (Installation guide page 39)
set valet mode
switch on TIMER on remote
or
set valet mode
set 4, 8 or 12 hour cycle (Installation guide page 37)
switch on TIMER on remote
When function TIMER is switched on the icon will shown and start will begin at the
preset time only if the temperature is equal or lower than the preset temperature in
programming menu 2-08 or 2-09.
4.19. AUTO mode + ——
Auto mode of arming/disarming using RFID technology. If that
function is set, system will switched on automatically – doors will
lock., if all the doors are locked and when the remote is far away from
vehicle (approx. 5 meters) during a time.
After getting closer to the vehicle (during a time) system will switch
off automatically – doors will unlock.
Press buttons and for long at the same time.
The remote will beep and the icon will show on remote.
You will turn it off by pressing the buttons and for long at the same time
again.
4.20. RFID transmitting automatically off + —
Alarm allows you to disable transmitting of identification by RFID system for AUTO function.
In this case, after 3 or 8 days of inactivity alarm (car in the garage), will stop transmitting RFID
information and this will reduce the consumption of alarm. After RFID off vehicle must be
unlocked by button and transmitting of identification by RFID will restored after power
on/off ignition.
Also, alarm cancel transmit RFID signal when low car battery is indicated (under
11,5V).
To Next Page
Loading...
