What to do if Magicard Tango 2e Printer shows 'Card not found' error?
If cards are failing to travel correctly through your Magicard printer, resulting in a “Card not found” error message, it might be due to dirty rollers or an incorrect card size. Clean the rollers. Also, ensure you are using the correct card size.
Why are cards printing incorrectly after switching film on Magicard printer?
If your Magicard printer is printing cards incorrectly after switching between YMCK and black film, it could be due to a failure to reset the driver settings or a used roll of dye film being fitted. To fix this, ensure that you set the correct driver settings for Colour Format and replace the dye film with a new roll.
Essential safety instructions for operating the printer to prevent hazards.
Details on unpacking the printer, identifying accessories, and checking contents.
Lists essential consumables like dye film, cleaning cards, and blank cards.
Procedure for correctly loading the dye film spool into the printer.
Table and guidance for choosing the correct dye-film based on print job requirements.
Step-by-step instructions for safely loading dye-film into the printer.
Details on available lamination film types and part numbers for the Tango +L.
Instructions for updating the printer's firmware using the support utility.
Solutions for common image quality issues like misregistration and color errors.
Troubleshooting dye film loading, positioning, and printing problems.
General| Print Resolution | 300 dpi |
|---|---|
| Card Capacity | 100 cards |
| Interface | USB |
| Print Technology | Dye Sublimation |
| Connectivity | USB |
| Card Types Supported | PVC |
| Print Capability | Single or Dual Sided |
| Operating System Compatibility | Windows 7, 8, 10 |
To Next Page