Flex Pro Transmitter Instruction Manual
April 2019
Page 13 of 25
Cranes, hoists, lifting devices and other material handling equipment can be large and can operate at high
speeds.
The operator should:
• continuously watch and monitor status of lifted loads
• know and follow cable and hook inspection procedures
The operator shall not:
• lift or move more than the rated load
• use the crane, hoist or lifting device to lift, support or transport people
• lift or carry any loads over people
• operate the crane, hoist or lifting device unless all persons, including the operator, are and remain
clear of the supported load and any potential pinch points
• operate a crane, hoist or lifting device when the device is not centered over the load
• operate a crane, hoist or lifting device if the chain or wire rope is not seated properly in the
sprockets, drum or sheave
• leave any load unattended while lifted
2.11 Specific System Warnings
The following specific operating safety tips should be strictly followed when operating a Flex Pro system:
• Check the Status LED on the transmitter for any signs of low battery power (See Section 5.3
Status Lights Indicators and Warnings on page 22).
• Check the Status LED on the transmitter for any signs of irregularities (See Section 5.3 Status
Lights Indicators and Warnings on page 22).
• Make sure the system is not set to the same channel as any other Flex systems in use within a
distance of 300 meters (900 feet).
• Never operate equipment with two transmitter handsets at the same time unless they are
programmed for such use.
To Next Page
Loading...
