41
13. Remove the shims of PTO shaft.
14. Tap the main PTO shat with the help of
mallet form the front side & draw the main
PTO shaft from the rear.
15. After removing the main PTO shaft, draw
out the PTO gear with front & rear PTO shaft
spacer.
16. Remove the remaining bearings.
17. Remove the PTO coupling.
18. Remove the roll pin of PTO shift lever with
the help of roll pin punch & draw out the
PTO shift lever with ball & spring.
19. Remove the bolt & spring lock washer of
PTO shifter shaft retaining plate with the
help of 8 mm spanner & remove the PTO
shifter retaining shaft.
20. Rotate & remove the PTO shifter by tapping
with the mallet from the outside.
21. Remove the PTO shifter oil seal.
22. Clean all the parts with the help of cleaning
fluid & inspect all the parts for wear &
damage, replace if necessary.
Note: Always Use new seals & circlips at the
time of assembly.
Dismantling of Brae Assembly
1. Remove 4 nos of hexagonal headed bolts
& washer, mounting the brake assembly to
the transmission with the 10 mm spanner.
2. Remove the Brake assembly with friction
disc & actuating disc assembly.
Mallet
Main PTO
Gear
Main PTO
Gear
Main PTO
Shaft
Rear
Spacer
Front
Spacer
Bearing
Bearing
PTO
Coupling
Mounting
Bolt
Brake
Assembly
Brake Assembly
Transmission
To Next Page
Loading...
