9
Engine Specifications
Engine
Type FMW100 Water Cooled Direct Injection
NA type Engine
No. of Cylinders 1
Bore / Stroke mm 100 / 110
Displacement cc 863.5
Rated Governed Speed 2300 + 50
Low Idle R.P.M. 1050 + 100
High Idle R.P.M. 2550 + 50
Valve Clearance Cold - Inlet - 0.1, Exhaust- 0.1, Hot - Inlet - 0.1,
Exhaust - 0.1
Air Cleaner Wire Mesh & Foam type Oil Bath
Nozzle Injection Pressure 247 to 261 kg/sqcm (250 + 8 bar)
Cooling System Water cooled pressurised, Cap Operating
Pressure 0.9 kg/sqcm, without thermostat
MANIFOLD, CYLINDER HEAD & VALVES
Inlet Valve
No of Inlet Valve 1
Stem Diameter (mm) 8.93 / 8.95
Port diameter (mm) 40 x 47
Clearance in guide,mm 0.05 to 0.08mm
Exhaust Valve
No of Exhaust Valve 1
Stem Diameter (mm) 8.93 / 8.95
Port diameter (mm) 32 x 38
Clearance in guide,mm 0.05 to 0.08mm
Tappet clearance Hot (mm) 0.1
Tappet clearance Cold (mm) 0.1
Valve Guides
No of Guides 2
Length Inlet & Exhaust (mm) 56
Inside diameter (mm) 9
Set Height of guide measured from 42
+ 0.1
cylinder head Topdeck
Height Inlet & Exhaust (mm) 56
To Next Page
Loading...
