easyTymp® Operating Manual
8
3.2.1.5 Installing the easyTymp®
The battery compartment is opened by gently pressing
the indentation and pulling the cover downwards.
Place the battery inside the compartment. Make sure
the battery contacts are correctly placed.
Replace the lid on the easyTymp® and push it upwards
t
o close the battery compartment.
If not in operation for longer periods, it is recommended
to remove the battery from the instrument.
3.2.1.6 Charging the battery
Th
e spare battery is stored in the charger in the back of
the cradle. Battery LED shows solid blue when the spare
battery in the cradle is fully charged. The LED will flash
as long as the battery is charging
Please observe the following precautions
Keep the battery fully charged.
Do not place the battery in fire or apply heat to the battery.
Do not damage the battery or use a damaged battery.
Do not expose the battery to water.
Do not short circuit the battery or reverse the polarity.
Use only the charger provided with the easyTymp®
To Next Page
Loading...
