Operating Instructions
35
8.3 Display Contrast
To change the contrast of the display, select
Display
from the set up
menu.
arrows to adjust the contrast. When done
adjusting the contrast press the right arrow button to
Save
and exit.
8.4 Instrument Details
To view the instrument details, select
Instrument Details
from the set
up menu. Instrument details will show th
e serial number of the
instrument, connected probe, firmware (embedded operating
software) version and a summary of other instrument settings.
8.5 DP Early Stop
The user can select how the instrument will operate when performing
a DPOAE test. With the
DP Early Stop feature off
completed at all frequencies included in the selected protocol. The test
is complete when all frequencies have been measured. If the
Stop
feature is
on,
the measurement will stop as soon as the
instrument can determine that the criteria for a PASS or REFER result
has been met. In this case some frequencies may not be measured,
but testing will be completed faster.
To change this setting, select
DP Early Stop
from the
Set Up
menu
Using the up and down arrow buttons on the control panel select
off
or
on
and then press the right arrow button to
select
and exit.
To Next Page
Loading...
Need help?
General
