Operating Instructions
29
After loading, check that the paper is straight and advances properly. Tear off any excess
paper by pulling the paper sharply towards you across the serrated tear bar. In the event of a
jam or other paper loading problem, release the lit and straighten the paper before closing
again.
Pressing the paper feed button when the printer is idle advances the paper. “Double-clicking”
the button (pressing and releasing the button twice in quick succession) prints a demo/test
message showing the printer firmware version and settings.
7
.4 Connecting the cradle to the Printer
Use the included printer connection cable to connect the cradle
to the printer. Connect the appropriate end of the connection
cable into the serial data port at the
Connect the opposite end of the data cable into the printer
connector on the underside of the cradle.
Place the two-position button located on the upper right of the
top side of the cradle in the raised position for printer use.
To Next Page
Loading...
Need help?
General
