14
Removing and fitting vibration damper,
replacing front crankshaft gasket
71
Fitting pilot clutch
Fig. 14
Before assembly clean all clutch parts,
see page 127.
Push pre-assembled clutch on to driver flange and
fasten it with interior bolts Á, 69 Nm.
Connect propshaft to clutch again and fit washer Â
with bolts À, 25 Nm.
Positions of individual parts are marked.
Comply with specified torques.
Caution:
Unblock the crankshaft drive!
1 2
3
To Next Page
Loading...
