E 300 Operator Interface
M&R Printing Equipment, Inc. - Glen Ellyn, Illinois
46
“Preheat” will change to “ON” for the selected time
of the preheat cycle, and the “Preheat” L.E.D. will
flash.
OPTIONS -
The next menu item is “OPTIONS”. To access the
“OPTIONS” menu item, press the “OPTIONS” key
located to the right of the “TIMERS” key. The
“OPTIONS” menu contains nine sub-menu items,
“Revolver Mode”, “Rotation”, “Index”, “Skip”,
“Pallets Size”, “Flash”, “Servo Off-Set”, “Glue
Applicator”, “Oiler” and “Ink Dip”.
NOTE: The sub-menu item for
“REVOLVER” appears only on
presses equipped with the
“REVOLVER” program option.
M&R REVOLVER SEQUENCING PROGRAM
(Optional)
The first sub-menu item is “Revolver mode”.
NOTE: The “REVOLVER”
option only appears on press-
es equipped with the
“REVOLVER” program option.
To access the Revolver mode of operation, press the
“ARROW DOWN” key one time, then press the
“ARROW RIGHT” key so that the flashing cursor is
located under the “>” to the left of the letter “R” in
“Revolver Mode”, then press the “ENTER” key one
time. The “Revolver Mode” display screen contains
“Revolver Mode ON/OFF”, “Index Delay”, “Stop
Alarm”, “Enter Program”, “Revolution Number”,
“Pallet No.:”, “Job No.”, “Job Clear” and “Alarm
Enabled ON/OFF”. When you first enter into this
message screen, you will note that the flashing cur-
sor automatically locates beneath the letter “R” on
i
IMPORTANT!
i
IMPORTANT!
Figure 6
>Revolver Mode: On
>Index Delay: Off
>Stop Alarm
>Enter Program
Revolution No. : 1
181716151413121110 9 8 7 6 5 4 3 2 1
To Next Page
Loading...
